800-150 Cisco Exam Questions and Free Practice Test

Question 13

Which Cisco UCS management platform is specifically designed for managing standalone Cisco UCS C-Series rack servers and E-Series servers?

A. Cisco Integrated Management Controller

B. Cisco UCS Central

C. Cisco UCS Manager

D. Cisco Intersight

Correct Answer:A

Question 14

DRAG DROP
800-150 dumps exhibit
Refer to the exhibit. Drag and drop the names of the field-replaceable units from the left onto the corresponding letters on the image of the Cisco NCS 5500 Series modular router.

Solution:

Does this meet the goal?

A. Yes

B. No

Correct Answer:A

Question 15

Which two configuration parameters are most critical to ensure optimal performance when configuring a network port for a newly installed IP phone in an enterprise environment? (Choose two.)

A. VLAN assignment

B. Link aggregation

C. Spanning Tree Protocol

D. Power over Ethernet

E. QoS classification

Correct Answer:AD

Question 16

Which term describes the physical range of radio frequency coverage provided by an access point in a wireless topology?

A. Service Set Identifier (SSID)

B. Basic Service Area (BSA)

C. Wireless LAN (WLAN)

D. Wireless LAN Controller (WLC)

Correct Answer:B

Question 17

What is the first action that must be taken before removing a standby supervisor module from a Cisco MDS 9700 Series Switch?

A. Shut down the entire switch.

B. Put themodule into out-of-service mode.

C. Disconnect all network interface cables.

D. Perform a manual failover to the standby supervisor.

Correct Answer:B

Question 18

DRAG DROP
Drag and drop the steps of the boot sequence process of a Cisco device into order on the right.
800-150 dumps exhibit
Solution:
Step 1 ?? Performs power-on self-test (POST)
Step 2 ?? Loads and runs bootstrap code (firmware)
Step 3 ?? Finds and loads the Cisco IOS software
Step 4 ?? Finds and loads the configuration
Step 5 ?? Runs the configured Cisco IOS software
This startup process is thoroughly described in the FLDTEC course and aligns with Cisco's standard IOS boot process:
POST (Power-On Self-Test): Verifies hardware functionality including memory and interfaces. This occurs immediately upon powering the device.
Bootstrap Code Execution: Bootstrap is a small program in ROM that initiates the boot process.
Cisco IOS Loading: Bootstrap locates and loads the IOS from flash memory or another source (e.g., TFTP).
Configuration Loading: The router then loads the startup-config from NVRAM (if available).
IOS Execution: Once the configuration is loaded, the device enters operational mode and executes the IOS with the loaded config.
This sequence is vital for field technicians to understand for troubleshooting boot failures or performing device recoveries.

Does this meet the goal?

A. Yes

B. No

Correct Answer:A

START 800-150 EXAM